DragonFly On-Line Manual Pages

Search: Section:  

SC_TRACEDIFF(1)        DragonFly General Commands Manual       SC_TRACEDIFF(1)


NAME

     sc_tracediff - display traceroute paths where the path has changed.


SYNOPSIS

     sc_tracediff [-a] [-m method] [-n] file1.warts file2.warts


DESCRIPTION

     The sc_tracediff utility displays pairs of traceroutes to a destination
     where the path has changed.  It takes two warts files as input and
     displays paths where a hop differs by its address.  The options are as
     follows:

     -a      dump all traceroute pairs regardless of whether they have
             changed.

     -m method
             specifies the method used to match pairs of traceroutes together.
             If dst is specified, traceroutes are matched if the destination
             IP address of both traces are the same.  If userid is specified,
             traceroutes are matched if the userid field of both traces are
             the same.  If dstuserid is specified, traceroutes are matched if
             the destination IP address and userid fields are the same.  By
             default, the destination IP address is used.

     -n      names should be reported instead of IP addresses, where possible.

     sc_tracediff can be useful in network monitoring to identify when a
     forward IP path has changed.  In this scenario, it is recommended that
     Paris traceroute is used with the same UDP source and destination ports
     for each execution of scamper so that only paths that have changed are
     identified, not merely alternate paths visible due to per-flow load-
     balancing.  By default scamper uses a source port based on the process
     ID, which will change with each execution of scamper.


EXAMPLES

     The command:

     scamper -O warts -o file1.warts -c 'trace -P udp-paris -s 31337' -f
     list.txt

     collects the forward IP paths towards a set of IP addresses found in
     list.txt using 31337 as the UDP source port value.  If the above command
     is adjusted to subsequently collect file2.warts, then we can identify
     paths that have subsequently changed with the command:

     sc_tracediff file1.warts file2.warts

     If Paris traceroute with ICMP probes is preferred, then the following
     invocation of scamper is appropriate:

     scamper -O warts -o file1.warts -c 'trace -P icmp-paris -d 31337' -f
     list.txt

     In this case, scamper uses 31337 as the ICMP checksum value in each
     probe.


SEE ALSO

     scamper(1),

     B. Augustin, X. Cuvellier, B. Orgogozo, F. Viger, T. Friedman, M. Latapy,
     C. Magnien, and R. Teixeira, Avoiding traceroute anomalies with Paris
     traceroute, Proc. ACM/SIGCOMM Internet Measurement Conference 2006.


AUTHOR

     sc_tracediff is written by Matthew Luckie <mjl@luckie.org.nz>.

DragonFly 6.5-DEVELOPMENT       April 21, 2011       DragonFly 6.5-DEVELOPMENT

Search: Section: