DragonFly On-Line Manual Pages

SENSORSD(8)            DragonFly System Manager's Manual           SENSORSD(8)

NAME
     sensorsd -- hardware sensors monitor

SYNOPSIS
     sensorsd [-d] [-c check]

DESCRIPTION
     The sensorsd utility retrieves sensor monitoring data like fan speed,
     temperature and voltage via sysctl(3).  When the state of any monitored
     sensor changes, an alert is sent using syslog(3) and a command, if speci-
     fied, is executed.

     By default, sensorsd monitors status changes on all sensors that keep
     their state, thus sensors that automatically provide status do not
     require any additional configuration.  In addition, for every sensor, no
     matter whether it automatically provides its state or not, custom low and
     high limits may be set, so that a local notion of sensor status can be
     computed by sensorsd, indicating whether the sensor is within or is
     exceeding its limits.

     Limit and command values for a particular sensor may be specified in the
     sensorsd.conf(5) configuration file.  This file is reloaded upon receiv-
     ing SIGHUP.

     The options are as follows:

     -c check
             Check sensors every check seconds.  The shortest reporting period
             for state changes will be three times this value.  The default is
             20.

     -d      Do not daemonize.  If this option is specified, sensorsd will run
             in the foreground.

FILES
     /etc/sensorsd.conf  Configuration file for sensorsd.

SEE ALSO
     sysctl(3), syslog(3), sensorsd.conf(5), syslogd(8)

HISTORY
     The sensorsd program first appeared in OpenBSD 3.5 and was imported into
     DragonFly 1.11.

CAVEATS
     Certain sensors may flip status from time to time.  To guard against
     false reports, sensorsd implements a state dumping mechanism.  However,
     this inevitably introduces an additional delay in status reporting and
     command execution, e.g. one may notice that sensorsd makes its initial
     report about the state of monitored sensors not immediately, but about 60
     seconds after it is started.

DragonFly 3.5                  October 19, 2008                  DragonFly 3.5