DragonFly On-Line Manual Pages

Search: Section:  

HOSTAPD_CLI(8)	       DragonFly System Manager's Manual	HOSTAPD_CLI(8)


hostapd_cli -- text-based frontend program for interacting with hostapd(8)


hostapd_cli [commands]


The hostapd_cli utility is a text-based frontend program for interacting with hostapd(8). It is used to query the current status. The hostapd_cli utility can show the current authentication status, dot11 and dot1x MIBs, etc. The hostapd_cli utility supports two modes: interactive and command line. Both modes share the same command set. Interactive mode is started when hostapd_cli is executed without any parameters on the command line. Commands are then entered from the con- trolling terminal in response to the hostapd_cli prompt. In command line mode, the same commands are entered as command line arguments.


The following commands may be supplied on the command line or at a prompt when operating interactively. mib Report MIB variables (dot1x, dot11) for the current interface. sta addr Report the MIB variables for the associated station with MAC address addr. all_sta Report the MIB variables for all associated stations. help Show usage help. interface [ifname] Show available interfaces and/or set the current interface when multiple are available. level debug_level Change the debugging level in hostapd(8). Larger numbers gener- ate more messages. license Display the full license for hostapd_cli. quit Exit hostapd_cli.


hostapd.conf(5), hostapd(8)


The hostapd_cli utility first appeared in FreeBSD 6.0.


The hostapd_cli utility was written by Jouni Malinen <jkmaline@cc.hut.fi>. This manual page is derived from the README file included in the hostapd distribution. DragonFly 4.3 August 19, 2006 DragonFly 4.3

Search: Section: